Content for TS 25.133 Word version: 18.0.0
3 Definitions, symbols and abbreviations
4 Idle Mode Tasks
5 UTRAN Connected mode mobility
6 RRC Connection Control
7 Timing and Signalling characteristics
...
...
3 Definitions, symbols and abbreviations p. 20
3.1 Definitions p. 20
3.2 Symbols p. 21
3.3 Abbreviations p. 22
3.4 Test tolerances p. 23
3.5 Additional notation |R13| p. 24
4 Idle Mode Tasks p. 25
4.1 Cell Selection p. 25
4.1.1 Introduction p. 25
4.2 Cell Re-selection p. 25
4.2.1 Introduction p. 25
4.2.2 Requirements p. 25
4.2.2.1 Measurement and evaluation of cell selection criteria S of serving cell p. 26
4.2.2.2 Measurements of intra-frequency cells p. 26
4.2.2.3 Measurements of inter-frequency FDD cells p. 27
4.2.2.4 Measurements of inter-frequency TDD cells p. 28
4.2.2.5 Measurements of inter-RAT GSM cells p. 29
4.2.2.5.1 Cell reselection based on cell ranking |R8| p. 29
4.2.2.5.2 Cell reselection based on priority information |R8| p. 29
4.2.2.5a Measurements of inter-RAT E-UTRA cells |R8| p. 30
4.2.2.6 Evaluation of cell re-selection criteria p. 32
4.2.2.7 Maximum interruption in paging reception p. 32
4.2.2.8 Number of cells in cell lists p. 33
4.2.2.8a Number of cells in cell lists (Increased UE carrier monitoring) |R12| p. 33
4.2.2.9 Additional requirements for measurement of inter-frequency and inter-RAT cells when MBMS reception is active |R6| p. 34
4.2.2.10 MTCH Interruption time |R7| p. 34
4.2.2.11 Reselection to CSG cells |R8| p. 34
4.3 MBSFN cluster selection |R7| p. 36
4.3.1 Introduction p. 36
4.4 MBSFN cluster reselection |R7| p. 36
4.4.1 Introduction p. 36
4.5 Minimization of Drive Tests (MDT) |R10| p. 37
5 UTRAN Connected mode mobility p. 38
5.1 FDD/FDD Soft Handover p. 38
5.1.1 Introduction p. 38
5.1.2 Requirements p. 38
5.2 FDD/FDD Hard Handover p. 39
5.2.1 Introduction p. 39
5.2.2 Requirements p. 39
5.2.2.1 Hard handover delay p. 39
5.2.2.2 Interruption time p. 39
5.3 FDD/TDD Handover p. 40
5.3.1 Introduction p. 40
5.3.2 Requirements p. 41
5.4 FDD/GSM Handover p. 42
5.4.1 Introduction p. 42
5.4.2 Requirements p. 42
5.4.2.1 Handover delay p. 42
5.4.2.2 Interruption time p. 42
5.4a FDD to E-UTRAN FDD Handover |R8| p. 43
5.4a.1 Introduction p. 43
5.4a.2 Requirements p. 43
5.4a.2.1 Handover delay p. 43
5.4a.2.2 Interruption time p. 43
5.4b FDD to E-UTRAN TDD Handover |R8| p. 44
5.4b.1 Introduction p. 44
5.4b.2 Requirements p. 44
5.4b.2.1 Handover delay p. 44
5.4b.2.2 Interruption time p. 44
5.5 Cell Re-selection in CELL_FACH p. 44
5.5.1 Introduction p. 44
5.5.2 Requirements p. 45
5.5.2.1 Cell re-selection delay p. 45
5.5.2.1.1 Intra frequency cell reselection p. 45
5.5.2.1.2 Inter frequency cell reselection p. 45
5.5.2.1.3 FDD-TDD cell reselection p. 46
5.5.2.1.4 FDD-GSM Cell Reselection p. 46
5.5.2.1.5 FDD-E-UTRAN Cell Reselection |R11| p. 47
5.5.2.1.6 Void
5.5.2.1A Cell reselection delay to CSG cells |R11| p. 47
5.5.2.1A.1 Reselection from a non CSG FDD to an inter-frequency FDD CSG cell p. 48
5.5.2.1A.2 Reselection from a non CSG FDD to an inter-RAT E-UTRA CSG cell p. 48
5.5.2.2 Interruption time p. 49
5.5.2.2.1 FDD-FDD cell reselection p. 49
5.5.2.2.2 FDD-TDD cell reselection p. 50
5.5.2.2.3 FDD-GSM cell reselection p. 50
5.5.2.3 Measurement and evaluation of cell selection criteria S of serving cell p. 51
5.6 Cell Re-selection in CELL_PCH p. 51
5.6.1 Introduction p. 51
5.6.2 Requirements p. 51
5.7 Cell Re-selection in URA_PCH p. 52
5.7.1 Introduction p. 52
5.7.2 Requirements p. 52
5.8 RACH reporting p. 52
5.8.1 Introduction p. 52
5.8.2 Requirements p. 52
5.9 Inter-RAT cell change order from UTRAN in CELL_DCH and CELL_FACH p. 52
5.9.1 Introduction p. 52
5.9.2 Requirements p. 53
5.9.2.1 Delay p. 53
5.9.2.2 Interruption time p. 53
5.10 Serving HS-DSCH cell change |R6| p. 54
5.10.3 Introduction |R10| p. 54
5.10.2 Requirements p. 54
5.11 Enhanced Serving HS-DSCH cell change |R8| p. 54
5.11.1 Introduction p. 54
5.11.2 Requirements p. 55
5.12 Interruption on Primary Uplink Frequency in DC-HSUPA |R9| p. 55
5.12.1 Introduction p. 55
5.12.2 Requirements p. 55
5.13 System information acquisition for CSG cell |R9| p. 55
5.13.1 Introduction p. 55
5.13.2 CSG SI acquisition delay p. 55
5.13.3 Interfrequency CSG decoding interruption p. 56
5.13.4 CSG reporting delay p. 56
5.14 System information acquisition for inter-RAT E-UTRA cell |R9| p. 56
5.14.1 Identification of a new CGI of inter-RAT E-UTRA FDD cell with autonomous gaps p. 56
5.14.2 Identification of a new CGI of inter-RAT E-UTRA TDD cell with autonomous gaps p. 57
5.14.3 ECGI reporting delay p. 57
5.15 Packet Loss Rate on Serving HS-DSCH Cells in Multi-Carrier HSDPA |R11| p. 57
5.15.1 Introduction p. 57
5.15.2 Requirements p. 58
6 RRC Connection Control p. 58
6.1 RRC Re-establishment p. 58
6.1.1 Introduction p. 58
6.1.2 Requirements p. 58
6.2 Void
6.3 Random Access p. 59
6.3.1 Introduction p. 59
6.3.2 Requirements p. 59
6.3.2.1 Correct behaviour when receiving an ACK p. 59
6.3.2.2 Correct behaviour when receiving an NACK p. 59
6.3.2.3 Correct behaviour at Time-out p. 59
6.3.2.4 Correct behaviour when reaching maximum transmit power p. 59
6.3.2.5 Correct behaviour when selecting 2 or 10msec TTI length for Enhanced Uplink in CELL_FACH state and idle mode |R11| p. 60
6.4 Transport format combination selection in UE p. 60
6.4.1 Introduction p. 60
6.4.2 Requirements p. 60
6.5 Maximum allowed UL TX Power p. 65
6.6 Void
6.7 CSG Proximity Indication for E-UTRAN and UTRAN |R9| p. 66
6.7.1 Introduction p. 66
6.7.2 Requirements p. 67
6.8 10ms Mode/20ms Mode switching in DCH |R12| p. 67
6.8.1 Introduction p. 67
6.8.2 Requirements p. 67
7 Timing and Signalling characteristics p. 67
7.1 UE Transmit Timing p. 67
7.1.1 Introduction p. 67
7.1.2 Requirements p. 68
7.2 UE Receive - Transmit Time Difference p. 68
7.2.1 Introduction p. 68
7.2.2 Requirements p. 69
7.3 UE timer accuracy p. 69
7.3.1 Introduction p. 69
7.3.2 Requirements p. 69
7.4 PRACH Burst timing accuracy |R6| p. 69
7.4.1 Introduction p. 69
7.4.2 Requirements p. 69
