Content for TS 36.101 Word version: 18.6.0
1…
3…
5…
6…
6.3…
6.5
6.6…
7…
8…
8.2.2…
8.3…
8.4…
8.5…
8.7…
8.9…
8.11…
8.13…
9…
9.3
9.4
9.5…
10…
11…
12…
14…
A…
B…
C…
C Downlink Physical Channels
D Characteristics of the interfering signal
E Environmental conditions
F Transmit modulation
G Reference sensitivity level in lower SNR
H Modified MPR behavior
I Supported Post Antenna Gain
$ Change history
C (Normative) Downlink Physical Channels p. 2011
C.1 General p. 2011
C.2 Set-up p. 2011
C.3 Connection p. 2011
C.3.1 Measurement of Receiver Characteristics p. 2011
C.3.2 Measurement of Performance requirements p. 2012
C.3.3 Aggressor cell power allocation for Measurement of Performance Requirements when ABS is Configured p. 2013
C.3.4 Power Allocation for Measurement of Performance Requirements when Quasi Co-location Type B: same Cell ID p. 2014
C.3.5 Simplified CA testing method p. 2014
C.3.6 Measurement of Receiver Characteristics for Narrowband IoT p. 2015
D (Normative) Characteristics of the interfering signal p. 2016
D.1 General p. 2016
D.2 Interference signals p. 2016
E (Normative) Environmental conditions p. 2017
E.1 General p. 2017
E.2 Environmental p. 2017
F (Normative) Transmit modulation p. 2019
F.1 Measurement Point p. 2019
F.2 Basic Error Vector Magnitude measurement p. 2019
F.3 Basic in-band emissions measurement p. 2020
F.4 Modified signal under test p. 2020
F.5 Window length p. 2022
F.5.1 Timing offset p. 2022
F.5.2 Window length p. 2022
F.5.3 Window length for normal CP p. 2022
F.5.4 Window length for Extended CP p. 2023
F.5.5 Window length for PRACH p. 2023
F.5.F Window length for category NB1 p. 2024
F.6 Averaged EVM p. 2024
F.7 Spectrum Flatness p. 2025
G Reference sensitivity level in lower SNR p. 2026
G.1 General p. 2026
G.2 Typical receiver sensitivity performance (QPSK) p. 2026
G.3 Reference measurement channel for REFSENSE in lower SNR p. 2032
H (Normative) Modified MPR behavior p. 2035
I (Normative) Supported Post Antenna Gain p. 2036
$ Change history p. 2037
