Tech-invite3GPPspaceIETFspace
21222324252627282931323334353637384‑5x

Content for  TS 25.141  Word version:  18.0.0

Top   Top   None   None   Next
1…   3…   6…   8…   A…

 

1  Scopep. 16

The present document specifies the Radio Frequency (RF) test methods and conformance requirements for UTRA Base Stations (BS) operating in the FDD mode. These have been derived from, and are consistent with the UTRA Base Station (BS) specifications defined in [1].
The present document establishes the minimum RF characteristics of the FDD mode of UTRA for the Base Station (BS).

2  Referencesp. 16

The following documents contain provisions which, through reference in this text, constitute provisions of the present document.
  • References are either specific (identified by date of publication, edition number, version number, etc.) or non specific.
  • For a specific reference, subsequent revisions do not apply.
  • For a non-specific reference, the latest version applies. In the case of a reference to a 3GPP document (including a GSM document), a non-specific reference implicitly refers to the latest version of that document in the same Release as the present document.
[1]
TS 25.104: "UTRA(BS) FDD; Radio transmission and Reception".
[2]
TS 25.942: "RF system scenarios".
[3]
TS 25.113: "Base station EMC".
[4]
ITU-R recommendation SM.329: "Unwanted emissions in the spurious domain ".
[5]
ITU-T recommendation O.153: "Basic parameters for the measurement of error performance at bit rates below the primary rate".
[6]
IEC 60721-3-3 (1994): "Classification of environmental conditions - Part 3: Classification of groups of environmental parameters and their severities - Section 3: Stationary use at weather protected locations".
[7]
IEC 60721-3-4 (1995): "Classification of environmental conditions - Part 3: Classification of groups of environmental parameters and their severities - Section 4: Stationary use at non-weather protected locations".
[8]
IEC 60068-2-1 (1990): "Environmental testing - Part 2: Tests. Tests A: Cold".
[9]
IEC 60068-2-2 (1974): "Environmental testing - Part 2: Tests. Tests B: Dry heat".
[10]
IEC 60068-2-6 (1995): "Environmental testing - Part 2: Tests - Test Fc: Vibration (sinusoidal)".
[11]
ITU-R recommendation SM.328: "Spectra and bandwidth of emissions".
[12]
TS 45.004: "Digital cellular telecommunications system (Phase 2+); Modulation".
[13]
TS 25.214: "Physical layer procedures (FDD)".
[14]
TS 25.213: "Spreading and modulation (FDD)".
[15]
TS 36.104: "Evolved Universal Terrestrial Radio Access (E-UTRA); Base Station (BS) radio transmission and reception".
[16]
TS 37.141: "E-UTRA, UTRA and GSM/EDGE; Multi-Standard Radio (MSR) Base Station (BS) conformance testing".
[17]
CEPT ECC Decision (13)03, "The harmonised use of the frequency band 1452-1492 MHz for Mobile/Fixed Communications Networks Supplemental Downlink (MFCN SDL)".
[18]
ITU-R Recommendation M.1545, "Measurement uncertainty as it applies to test limits for the terrestrial component of International Mobile Telecommunications-2000".
Up

Up   Top   ToC