Content for TS 45.056 Word version: 18.0.0
1 Scope p. 6
The present document specifies the requirements for the CTS-Fixed Part (CTS-FP) transceiver of the digital mobile cellular and personal communication systems operating in the 900 MHz (P-GSM and E-GSM) and 1800 MHz band (GSM 900 and DCS 1800), and specifies the Radio subsystem frequency control implemented in the CTS-Fixed Part.
Unless otherwise stated, the requirements defined in the present document apply to the full range of environmental conditions specified for the CTS-FP equipment (see Annex C).
2 References p. 6
The following documents contain provisions which, through reference in this text, constitute provisions of the present document.
- References are either specific (identified by date of publication, edition number, version number, etc.) or non specific.
- For a specific reference, subsequent revisions do not apply.
- For a non-specific reference, the latest version applies. In the case of a reference to a 3GPP document (including a GSM document), a non-specific reference implicitly refers to the latest version of that document in the same Release as the present document.
[1]
GSM 01.04: "Digital cellular telecommunications system (Phase 2+); Abbreviations and acronyms".
[2]
GSM 03.22: "Digital cellular telecommunications system (Phase 2+); Functions related to Mobile Station (MS) in idle mode and group receive mode".
[3]
GSM 03.52 : "Digital cellular telecommunications system (Phase 2+); GSM Cordless Telephony System (CTS); Lower layers of the CTS radio interface; Stage 2".
[4]
GSM 04.56 : "Digital cellular telecommunications system (Phase 2+); GSM Cordless Telephony System (CTS); CTS radio interface layer 3 specification".
[5]
GSM 05.01: "Digital cellular telecommunications system (Phase 2+); Physical layer on the radio path General description".
[6]
GSM 05.02: "Digital cellular telecommunications system (Phase 2+); Multiplexing and multiple access on the radio path".
[7]
GSM 05.04: "Digital cellular telecommunications system (Phase 2+); Modulation".
[8]
GSM 05.05: "Digital cellular telecommunications system (Phase 2+); Radio transmission and reception".
[9]
GSM 05.08: "Digital cellular telecommunications system (Phase 2+); Radio subsystem link control".
[10]
GSM 05.10: "Digital cellular telecommunications system (Phase 2+); Radio subsystem synchronization".
[11]
GSM 11.56: "Digital cellular telecommunications system (Phase 2+); CTS-Fixed Part conformance specification".
[12]
GSM 03.56: "Digital cellular telecommunications system (Phase 2+); GSM Cordless Telephony System (CTS); CTS Architecture Description; Stage 2".
3 Definitions and abbreviations p. 7
3.1 Definitions p. 7
For the purposes of the present document, the following terms and definitions apply:
CTS Mobile Station:
GSM-MS supporting CTS.
CTS Fixed Part:
CTS-FP is a device which acts as a link between the CTS-MS and the fixed network.
GSM-CTS:
Cordless Telephony System based on GSM.
3.2 Abbreviations p. 7
Abbreviations used in the present document are listed in GSM 01.04. In addition, the following abbreviations are used:
AFA
Adaptive Frequency Allocation
CTS
Cordless Telephony System
CTS-FP
CTS-Fixed Part
CTS-MS
CTS-Mobile Station
GFL
Generic Frequency List
TFH
Total Frequency Hopping
