Content for TS 22.003 Word version: 18.0.1
This Technical Specification (TS) describes and defines a recommended set of Circuit Teleservices to be supported by a PLMN in connection with other networks as a basis for defining the network capabilities required.
The following documents contain provisions which, through reference in this text, constitute provisions of the present document.
-
References are either specific (identified by date of publication, edition number, version number, etc.) or non specific.
-
For a specific reference, subsequent revisions do not apply.
-
For a non-specific reference, the latest version applies. In the case of a reference to a 3GPP document (including a GSM document), a non-specific reference implicitly refers to the latest version of that document in the same Release as the present document.
[1]
TR 21.905: "Vocabulary for 3GPP Specifications"
[2]
TS 22.001: " Principles of circuit telecommunication services supported by a Public Land Mobile Network (PLMN)".
[3]
TS 22.002: "Circuit Bearer Services (BS) supported by a Public Land Mobile Network (PLMN)".
[4]
TS 22.004: " General on supplementary services".
[5]
TS 42.068: "Voice Group Call Service (VGCS) - Stage 1".
[6]
TS 42.069: "Voice Broadcast Service (VBS) - Stage 1".
[7]
TS 23.040: " Technical realization of the Short Message Service (SMS) Point to Point (PP)".
[8]
TS 23.041: " Technical realization of Short Message Service Cell Broadcast (SMSCB)".
[9]
TS 24.008: "Mobile radio interface layer 3 specification".
[10]
TS 27.001: : " General on Terminal Adaptation Functions (TAF) for Mobile Stations (MS)".
[11]
TS 27.005: " Use of Data Terminal Equipment - Data Circuit terminating Equipment (DTE - DCE) interface for Short Message Service (SMS) and Cell Broadcast Service (CBS)".
[12]
ITU-T Recommendation T.4: "Standardization of group 3 facsimile apparatus for document transmission".
[13]
ITU-T Recommendation T.30: "Procedures for document facsimile transmission in the general switched telephone network".
[14]
Abbreviations used in this TS are listed in
TR 21.905.
Teleservices supported by a PLMN are described by a number of attributes which are intended to be largely independent.
These attributes are described and defined in specification
TS 22.001.
They are grouped into three categories:
-
High layer attributes;
-
Low layer attributes (describing the Bearer capabilities which support the Teleservice).
-
information transfer attributes;
-
access attributes.
-
General attributes.
Figure 1 shows the relationship between the different categories of services attributes, and their scope within a Teleservice.
Table 1 gives the list of the attributes. For the definitions and possible values of these attributes, see
TS 22.001.
1. High layer capabilities | 1.1 Type of user information | Dominant Teleservice attribute category |
1.2 Layer 4 protocol functions | |
1.3 Layer 5 protocol functions | Secondary attributes |
1.4 Layer 6 protocol functions | Secondary attributes |
1.5 Layer 7 protocol functions | |
2. Low layer capabilities (describing the Bearer capability which supports the Teleservice) | 2.1 Information transfer | Secondary attributes |
2.1.1 Information transfer capabilities
| Secondary attributes |
2.1.2 Information transfer mode
| Secondary attributes |
2.1.3 Information transfer rate
| Individual services (in the category) |
2.1.4 Structure
| |
2.1.5 Establishment of communication
| |
2.1.6 Communication configuration
| |
2.1.7 Symmetry
| |
2.2 Access (TS 22.001) | Qualifying attributes |
2.2.1 Signalling access
| Qualifying attributes |
2.2.2 Information access
| Qualifying attributes |
2.3 Interworking | Qualifying attributes |
2.3.1 Terminating network type
| Qualifying attributes |
2.3.2 National/international interworking
| Further specify the individual services |
2.3.3 Interface of terminal equipment
| |
3. General | 3.1 Supplementary services provided | |
3.2 Quality of service | |
3.3 Operational and commercial | |
Table 2 presents a list of all Teleservices categories and of individual Teleservices and the associated dominant and secondary attributes.
The annex contains a data sheet per Teleservice with all attributes and comments.
According to specification
TS 22.001 the Bearer Capability defines the technical features of a Teleservice as they appear to the user at the customer access point or an appropriate interface of a fixed network. The Bearer Capability is characterized by information transfer, access and interworking attributes. The same set of attributes as for a Bearer Service is used. A Bearer Capability is associated with every Teleservice.
Dominant attribute |
Category of teleservice |
Individual Teleservice |
Type of user information |
No |
Name |
No |
Name |
Speech |
1 | Speech transmission |
11 |
Telephony |
12 |
Emergency Calls |
Short message |
2 | Short message service |
21 |
Short message MT/PP |
22 |
Short message MO/PP |
23 |
Cell Broadcast Service |
Facsimile |
6 | Facsimile transmission |
61 |
Alternate speech and facsimile group 3 |
T (1) NT (2) |
62 |
Automatic Facsimile group 3 |
T (1) NT (2) |
Speech |
9 | Voice Group service (3) |
91 |
Voice Group Call Service |
92 |
Voice Broadcast Service |
NOTE 1:
The transparent facsimile services apply to GERAN A/Gb mode of operation only.
NOTE 2:
The non-transparent facsimile services apply to UTRAN only.
NOTE 3:
The Voice Group Services, TS 91 and TS 92 apply to GERAN A/Gb mode of operation only.
|